Download
Download

Download Manuals, Datasheets, Software and more:

DOWNLOAD TYPE
MODEL or KEYWORD

What is the connection to get LTC into the WVR6000/WVR7000 series?

Question :

What is the connection to get LTC into the WVR6000/WVR7000 series?

Answer :

An LTC is input through the 15-pin Remote connector on the rear panel. To input an LTC signal, you need to construct a cable.  This cable has four wires from the Remote connector, two to an RCA connector and two to a BNC.

Pin 7 of the Remote connector is connected to the center pin of the RCA connector, and pin 6 is connected to the shield of the RCA connector.

Pin 8 of the Remote connector is connected to the center pin of the BNC and pin 6 goes to the shield of the BNC.

LTC Signal Amplitude Range , 0.2 V p-p to 5.0 V p-p balanced differential or single-ended.

NOTE : Apply a signal to only one connector at a time.


This FAQ Applies to:

No product series

Product:

FAQ ID 61216

View all FAQs »