質問:
DPO7000+DPO70000+DSA70000+VM6000: How do I enable the VGA port to view the scope display on an external monitor?
回答:
Here is the process to enable the DPO7000 scope display(VGA port)on an external monitor/projector:
- Connect the monitor to the SCOPE ONLY VGA port with the scope turned off.
- Power on the monitor.
- Power on the scope. The external monitor display should have the scope display after the scope boots.
- If the scope display is not shown on the monitor, minimize the scope application.
- Right-click on the Desktop and select Properties
- Go to Settings and click on the Advanced tab (the resulting window should look similar to the one below)
- In Displays section make sure Monitor and Panel are setup the same as the screenshot below.
FAQの該当製品:
製品シリーズなし
製品:
FAQ ID 55431
すべてのFAQを表示 »