Contact us

Call

Call us at

Available 6:00 AM – 5:00 PM (PST) Business Days

Download

Download Manuals, Datasheets, Software and more:

DOWNLOAD TYPE
MODEL or KEYWORD

Feedback

Tektronix Receiver Test Automation Software for PCIe 3.0 (Base and CEM), PCIe 4.0 (Base and CEM), PCIe 5.0 (Base and CEM), PCIe 6.0 (Base and CEM) , PCIe PLL Bandwidth (Gen 3/4/5/6), USB4 (Gen 2/3 Legacy and Rounded) and USB4v2 Gen4 calibration and receiver tests (Compliance & Beyond Compliance)

The TekRxTest Automation Software supports PCIe 3.0 (Base and CEM), PCIe 4.0 (Base and CEM), PCIe 5.0 (Base and CEM),PCIe 6.0 (Base and CEM), PCIe PLL Bandwidth (Gen 3/4/5/6), USB4 (Gen 2/3 Legacy and Rounded) calibration and USB4v2 Gen4 calibration and receiver tests (Compliance & Beyond Compliance).The PCIe calibration and tests are in accordance with PCI Express Base Specification Revision 6.2and PCI Express Card Electromechanical Specification 0.7.The USB4 (Gen 2/3 Legacy and Rounded) calibration and tests are in accordance with theUSB4 Electrical CTS Revision 1.02.The USB4v2 Gen4 calibration and tests are in accordance with the USB4 Version 2 Gen4 CTS Revision 0.9.The Calibration procedure is done by connecting the output of the BERT PPG to the Real-time Oscilloscope through aspecialized set of fixtures and cables. The BERT can be programmed to add different amounts of random jitter, sinusoidal jitter, differential, andcommon mode interference along with variable signal amplitude, preshoot, and de-emphasis and the different parametersare calibrated at two test points.The Receiver tests are accomplished by connecting the output of BERT PPG (which can produce specific test patterns)to the input of the DUT through the same set of fixtures and cables, on which the calibration was done.In case of the PCIe Receiver tests, the Output of the DUT is connected to the BERT error detector to identify biterrors on the DUT Tx traffic, either during loopback or during sweep of one of the stress parameters.Any error detected can be assumed to come from the DUT Tx path as a result of either the DUT experiencing a badbit-decision at its receiver or uncompensated back-channel loss at the error detector of the BERT. Additionally,DUT Tx traffic can be analyzed to verify the DUT responsiveness to various requests put forward by the BERT duringlink training process. The Software includes Calibration and JTOL for PCIe 3.0/4.0/5.0/6.0, and Tx/Rx Link Equalization test for PCIe3.0/4.0/5.0/6.0 CEM. In the case of PCIe PLL BW (Gen 3/4/5/6), the BERT can be programmed to add different amounts of sinusoidal jitter.Post Calibration, the output of the DUT is connected to the Real-time Oscilloscope, to measure the Transmitter DUT‚sPLL bandwidth and peaking.In case of USB4 (Gen 2/3 Legacy and Rounded) and USB4v2 Gen4, post calibration, the output of the DUT isconnected to the Wilder microcontroller to identify the bit errors on the DUT Tx traffic after preset negotiationis done using the ETT tool while sweeping one of the stress parameters.

This software applies to: DPS77004SX, DPS75904SX, DPS75004SX, DPO73304SX, DPO73304DX

Related Product Information