How do I set up a RS232 bus decode?
The procedure to set up a RS232 bus decode and trigger is simple once you understand the basics. First you need to have the correct module or scope option. Second make sure your signal is on screen and taking up as much of the screen as possible with good resolution, this will require having proper probes and knowledge about your signal. Turn on the bus option, and start by setting the channel and threashold levels. Once this is done you will begin to see your signal decode. Next adjust some of the small things such as bit rate and how you want to have the bus displayed such as Hex or binary or ASCII.
If you trying to decode on a Windows XP or Windows 7 scope the options will be different and more information can be found on their corresponding datasheet pages. Many of the concepts of decoding and triggering on a bus signal are the same same and can be applied from the lower end oscilloscopes.
This FAQ Applies to:
Product Series: DPO7000 MDO3000 Mixed Domain Oscilloscope MDO4000C Mixed Domain Oscilloscope MSO / DPO70000 Mixed Signal Oscilloscope MSO/DPO2000B Mixed Signal Oscilloscope MSO3000 / DPO3000 MSO4000 / DPO4000 MSO/DPO5000B Mixed Signal Oscilloscope
FAQ ID 64761View all FAQs »