Frequently Asked Questions

FAQ FAQ ID Sort ascending
How can I invert the channel on the 5 or 6 series MSO?

The invert feature is not available in the channel menu.

The invert channel feature on the 5 or 6 series MSO is supported via the math channel.

Here is the setup procedure:

1)  Click on "Add New Math"

2)  Select the Math Type to "Advanced"

This FAQ applies to:
MSO54, MSO56, MSO58, MSO58LP, MSO64
Where can I locate the visual trigger setup on the 5 or 6 series MSO?

The visual trigger option is not listed in the trigger type selection initially.  To setup the visual trigger, simply click on the "DRAW A BOX" icon (located in the lower right corner of the display) to draw the areas for the visual trigger.  After the visual trigger areas are defined, the visual

This FAQ applies to:
MSO54, MSO56, MSO58, MSO58LP, MSO64
THS3000 Transferring saved waveforms to PC via Open Choice Desktop.

Press the “Save” button to access the Save waveform menu.

This FAQ applies to:
THS3014, THS3014-TK, THS3024, THS3024-TK
Replacing Fuses/Changing Line Voltage DMM6500 DAQ6510

This FAQ applies to:
DAQ6510, DAQ6510/7700, DMM6500
Installing KTTI Communication Modules DMM6510 DAQ6500

1. Remove the Communication Accessory Cover from the rear panel of the instrument.

2. Insert the Accessory Card into the slot.

This FAQ applies to:
DAQ6510, DAQ6510/7700, DMM6500
What is peak spikes detection on Model 2001 and 2002 DMMs?

Peak spikes feature on Model 2001 and 2002 DMMs captures voltage transients with pulse widths as short as a 1usec.

It can also measure the peaks of AC waveforms up to 1MHz.

The attached application note discusses this feature in detail.

This FAQ applies to:
2001, 2002.
How to take and store data using KI-TOOL with Model 2110 DMM.

First, Here is a procedure to save data into a record.

This FAQ applies to:
2110-100, 2110-100-GPIB, 2110-120, 2110-120-GPIB, 2110-220, 2110-220-GPIB, 2110-240, 2110-240-GPIB
What are the different communication languages available on the Model 2450?

There are three different communication languages.
1. TSP - TSP(Test Script Processing) are the ICL commands.
2. SCPI - This is the Model 2450 SCPI commands.
3. SPCI 2400 - This is the Model 2400 emulation mode

This FAQ applies to:
Is it possible to establish a peer to peer ethernet connection on the 5 Series MSO?

Yes. To setup a peer to peer connection, you must manually configure the IP and subnet mask address on both the scope and your computer. You can then use an ethernet cable connected directly between the scope and computer.  This will work on the Linux and Windows version of the 5 Series MSO.

This FAQ applies to:
MSO54, MSO56, MSO58
How can I tell if my 5 Series MSO is running on Windows?

There are three indicators to look for. A Windows scope will have the Applications menu at the top center of the screen and minimize/maximize/close buttons on the top right. In addition, if you tap at the bottom of the screen, the Windows Taskbar should appear.

This FAQ applies to:
MSO54, MSO56, MSO58

Download Manuals, Datasheets, Software and more:

Go to top