Q: I currently have a MSO58B model oscilloscope I am using to automate a test setup. I am using pyvisa and an NI-VISA driver. So far this has worked well. I have a digital logic probe, TLP058 plugged into channel 7 of this oscilloscope. I am attempting to automate the configuration of this digital channel. I am struggling to get the digital channel to appear on the display. I can manually get this channel to appear by simply pressing on the "7" button at the bottom of the waveform display on the oscope. I would like to issue a SCPI command to do the same.
What is the appropriate set of SCPI commands to cause a digital channel to appear on the waveform display?
A: :DISPLAY:GLOBAL:CH7:STATE 1
Contactez-nous
Chat en direct avec un représentant Tek. Service disponible de 9 h à 17 h, CET jours ouvrables.
Téléphone
Appelez-nous au
Disponible de 9 h à 17 h CET jours ouvrables.
Télécharger
Télécharger des manuels, des fiches techniques, des logiciels, etc. :
Feedback