MSO58 What is the appropriate set of SCPI commands to cause a digital channel to appear on the waveform display?

Q: I currently have a MSO58B model oscilloscope I am using to automate a test setup. I am using pyvisa and an NI-VISA driver. So far this has worked well. I have a digital logic probe, TLP058 plugged into channel 7 of this oscilloscope. I am attempting to automate the configuration of this digital channel. I am struggling to get the digital channel to appear on the display. I can manually get this channel to appear by simply pressing on the "7" button at the bottom of the waveform display on the oscope. I would like to issue a SCPI command to do the same.
What is the appropriate set of SCPI commands to cause a digital channel to appear on the waveform display? 


A: :DISPLAY:GLOBAL:CH7:STATE 1