Q: I currently have a MSO58B model oscilloscope I am using to automate a test setup. I am using pyvisa and an NI-VISA driver. So far this has worked well. I have a digital logic probe, TLP058 plugged into channel 7 of this oscilloscope. I am attempting to automate the configuration of this digital channel. I am struggling to get the digital channel to appear on the display. I can manually get this channel to appear by simply pressing on the "7" button at the bottom of the waveform display on the oscope. I would like to issue a SCPI command to do the same.
What is the appropriate set of SCPI commands to cause a digital channel to appear on the waveform display?
A: :DISPLAY:GLOBAL:CH7:STATE 1
연락처
텍트로닉스 담당자와 실시간 상담 6:00am-4:30pm PST에 이용 가능
전화
전화 문의
9:00am-6:00PM KST에 이용 가능
다운로드
매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.
피드백