I have two GPIB-VXI/C GPIB Slot 0 controllers. How do I set the GPIB address of the second GPIB controller?

I have two GPIB-VXI/C GPIB Slot 0 controllers. How do I set the GPIB address of the second GPIB controller?

Information on how to perform this change is provided in the "Change Configuration Information" paragraph of section 4 in the National Instruments GPIB-VXI/C User Manual. These are the basic steps to make the needed changes.

1. Connect an ANSI terminal or emulation program to the Slot-0 serial port.
2. Set the communication protocol for 9600,8,N,1
3. Power up the VXIbus mainframe.
4. At the prompt, enter "CONF".
5. Select #3.
6. Select #6.
7. Change GPIB Primary Address to 2 (or what ever you prefer).
8. Select "Q".
9. Select #5.
10. Select #6.