Contactez-nous

Chat en direct avec un représentant Tek. Service disponible de 9 h à 17 h, CET jours ouvrables.

Téléphone

Appelez-nous au

Disponible de 9 h à 17 h CET jours ouvrables.

Télécharger

Télécharger des manuels, des fiches techniques, des logiciels, etc. :

TYPE DE TÉLÉCHARGEMENT
MODÈLE OU MOT CLÉ

Feedback

Installing SignalVu-PC on an MSO5, 6, and DPO 7 Series. Licenses needed and where to install

Model: MSO66B | Subject: Software / Firmware | Published: October 2026 | FAQ ID: KB-04016
Question: My team has procured the CONNL-SVPC license for installing SignalVu on our MSO66B.
The SUP6-SV-RFVT license is already included in the scope.
I would like to request step-by-step instructions to install SignalVu-PC on our MSO.
 
 
Answer: The latest version at this time is SignalVu-PC is V5.7.0161 See below link for tek.com
https://www.tek.com/en/support/software/application/signalvupc-vector-signal-analysis-software-v570161
Instructions for installation are at that link also.
 
Needed.
Windows drive (SSD) on the scope
CONNL-SVPC licnese, in SignalVu-PC
SV-RFVT  License on the scope.

Important Notes:
SignalVu-PC is in stalled on the windows drive (windows side) of the scope.
The CONNL-SVPC license needs to be checked out to a PC, using the HOST ID from SignalVu-PC running on the windows side of the scope.
When doing the check out select PC or non Tektronix instrument.
Same for the any other SignalVu-PC license options (like SignalVu-PC VSA).
The SV-RFVT license should be checked out to the Scope using the Model, Serial number and HOST ID from the Help About screen on the scope.