연락처

텍트로닉스 담당자와 실시간 상담 6:00am-4:30pm PST에 이용 가능

전화

전화 문의

9:00am-6:00PM KST에 이용 가능

다운로드

매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.

다운로드 유형
모델 또는 키워드

피드백

How do I test a SCR for Peak Reverse Blocking Current on my curve tracer?

질문:

How do I test a SCR for Peak Reverse Blocking Current on my curve tracer?

답변:

Peak Reverse Blocking Current - IRRM

 What It Is:

With no gate signal applied, peak reverse blocking current is the maximum reverse current that flows with the SCR in the blocked (Off) state.  Peak reverse blocking current is equal to peak forward blocking current but in the opposite direction.

On the curve tracer, the anode is connected to the Collector Supply and the gate is held open.

What The Display Shows:

The display shows anode voltage on the horizontal axis, and the resulting anode current on the vertical axis.  The specification is met when at the specified reverse voltage, reverse current is less than or equal to the specified maximum.

How To Do It:

1. Set controls:

            A: Max Peak Volts to the lowest setting above the specified VRRM

            B: Max Peak Power Watts to the lowest setting that satisfies (IRRM x VRRM)

            C: Horizontal Volts/Div to display VRRM between the 5th and 10th horizontal divisions

            D: Vertical Current/Div to display IRRM between the 5th and 10th vertical  divisions

            E: Collector Supply Polarity to -DC

            F: Configuration to (Base/Open, Emitter/Common)

            K: Variable Collector Supply to minimum % (full ccw)

            L: Dot Cursor (On)

2. Apply power to the SCR:

            A: Position the Left/Right switch as appropriate

            B: Slowly increase Variable Collector % until the specified VRRM is attained

3. Compare to data sheet specifications:

            A: Check that at the specified VRRM, IRRM is less than or equal to the specified maximum


이 FAQ는 다음에 적용 됩니다:

제품 시리즈 없음

제품:

FAQ ID 52711

모든 FAQ 보기 »