與我們聯絡

與 Tek 業務代表即時對談。 上班時間:上午 6:00 - 下午 4:30 (太平洋時間)

致電

請致電

與 Tek 業務代表即時對談。 上班時間:上午 8:30 - 下午 5:30 (太平洋時間)

下載

下載手冊、產品規格表、軟體等等:

下載類型
機型或關鍵字

意見回饋

How do I display 2-line or 2-field sweeps on the composite waveform of a WFM700?

問題:

How do I display 2-line or 2-field sweeps on the composite waveform of a WFM700?

答案:

In the component overlay display modes you should see buttons in the sweep menu for 2-line, 2-field and magnified displays. These options are not available in the parade display mode or in the composite color space because the SDI-to-composite conversion is too processor intensive and doesn't leave enough CPU cycles to do more advanced sweeps on a WFM700.

These modes are normally used to view the waveform between lines or fields and/or make timing measurements on them. It is important to note however that in the case of an SDI stream this information is meaningless. All of the data between the lines or fields in the waveform display is fabricated by the WFM700 since it does not exist in the SDI signal.


此常見問答集適用於:

沒有任何產品系列

產品:

常見問答集 ID 63546

檢視所有常見問答集 »