연락처
텍트로닉스 담당자와 실시간 상담 6:00am-4:30pm PST에 이용 가능
전화
전화 문의
9:00am-6:00PM KST에 이용 가능
다운로드
매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.
피드백
5 μH LISN for Tektronix EMC pre-compliance
EMI-LISN5UH (TEKBOX TBOH01 offered by Tektronix)
The EMI-LISN5UH is the TEKBOX TBOH01 5 μH LISN. This device is required to set up conducted noise measurements of DC-powered devices and is designed to be used for EMC pre-compliance testing in the frequency range of 150 kHz to 110 MHz (according to the CISPR-25 standard, ISO 7637-2, ISO11452-2/4/5 and with limitations DO-160/ED-14G). The LISN is inserted into the supply line of the DUT (Device Under Test). Conducted noise that is present at the supply terminals of the DUT can be measured at the BNC connector using a spectrum analyzer or a measurement receiver. The source (supply) terminal and the DUT terminal are decoupled by a 5 μH inductor.
Key features
- Frequency Range: 100 kHz to 110 MHz
- DC resistance: 40 mΩ
- Maximum current: 10 A
- Nominal operating voltage range: 0 to 60 V DC
- Built in surge protection
- Terminals suitable to clamp external source capacitors
Specifications
- 5 μH LISN
- Frequency range
- 100 kHz –110 MHz
- DC resistance
- 40 mΩ
- Maximum current
- 10 A
- Nominal operating voltage range
10 to 60 V DC (1 GHz when insertion loss measured between DUT terminals and BNC connector; source
terminals shorted)
- Absolute maximum rating
- 200 V 1
- Impedance
1The operating voltage range is limited to 60V DC for safety reasons. Though the component rating of the LISN is ≥ 200V, the positive supply voltage could accidentally be connected to the negative terminal of the LISN and thereby to the LISN housing. Under this circumstance, a DC voltage > 60V could cause a lethal electric shock when touching the housing.
Ordering information
EMI-LISN5UH 5 μH LISN
| Item | Description |
|---|---|
| EMI-LISN5UH | 5uH DC Line Impedance Stabilization Network (LISN) |