질문:
TDSHT3 shows that the signal overshoot and undershoot is high. What can I do?
답변:
If you suspect the probing is causing the Overshoot and undershoot problem, please consider the following:
Make sure that you are using the correct probe. Check the signal rise time and Probe’s typical rise time. If the probe typical rise time is greater than the signal rise time, the overshoot is expected. Use a higher end probe for the measurement.
Try avoiding using probe adaptors. (Square pin adaptors may introduce overshoots)
이 FAQ는 다음에 적용 됩니다:
제품 시리즈 없음
제품:
FAQ ID 59826
모든 FAQ 보기 »