AFG1062 no output with external triggered arbitrary burst

Question:

When I use a custom made arbitrary wave form, set the modulation to burst and the trigger source to external it is not possible to get any signal out of the device.

Answer:

This was a known limitation on AFG1062's that had firmware v1.0.4 or lower. This limitation has been resolved with the installation of firmware v1.0.5 which can be downloaded from Tek.com.

  • Up
    50%
  • Down
    50%

This FAQ Applies to:

Product Series: AFG1000 Arbitrary/Function Generator

Product: AFG1062

FAQ ID : 247536

View all FAQs »
Downloads
Download

Download Manuals, Datasheets, Software and more:

Go to top