연락처

텍트로닉스 담당자와 실시간 상담 6:00am-4:30pm PST에 이용 가능

전화

전화 문의

9:00am-6:00PM KST에 이용 가능

다운로드

매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.

다운로드 유형
모델 또는 키워드

피드백

제품 지원 및 다운로드

텍트로닉스 제품 지원 센터

'텍크놀로지(Tek-nology)'를 개발하는 일은 행복하지만, 동시에 매우 바쁘다는 걸 알고 있습니다. 이에. 텍트로닉스는 현재 출시되는 모든 제품과 단종된 여러 제품에 대한 설명서와 데이터 시트, 소프트웨어를 쉽게 다운로드할 수 있도록 제품 지원 센터를 만들었습니다. 사용 중인 제품명을 입력해 주시기만 하면 텍스로닉스가 보유하고 있는 모든 정보를 알려 드리겠습니다.

선택한 제품 모델은 단종된 제품이며 다음 지원 정보가 제공됩니다.

  • 매뉴얼 매뉴얼 유형 부품 번호: 릴리즈 날짜
    Tektronix BERTScope

    Clock Recovery Declassification & Securities Instructions

    기밀 해제 077110200
    Tektronix BERTScope

    BSA & BA Remote Control Guide Programmer Manual

    프로그래머 077069605
    Tektronix BERTScope

    BSA & BA Remote Control Guide Programmer Manual

    프로그래머 077069604
    Tektronix BERTScope

    BSA & BA Remote Control Guide Programmer Manual

    프로그래머 077069603
    Tektronix BERTScope

    Clock Recovery Instruments Quick Start User Manual

    주 사용자 071285202
    Tektronix BERTScope

    BSAPCI3 Instructions

    사용자 071304600
    Tektronix BERTScope

    BSA & BA Remote Control Guide Programmer Manual

    프로그래머 077069602
    Tektronix BERTScope

    Clock Recovery Instruments Quick Start User Manual.

    주 사용자 071285201
    Tektronix BERTScope

    BSA & BA Remote Control Guide Programmer Manual

    프로그래머 077069601
    BERTScope Clock Recovery Quick Start Guide

    This Quick Start User Manual supports the Tektronix BERTScope CR125A, CR175A, and CR286A Clock Recovery instruments. Quick Start User Manual

    사용자 077055700
    BERTScope

    Clock Recovery Instruments Quick Start User Manual

    사용자 071285200
  • 기술 문서 문서 유형 릴리즈 날짜
    BERTScope® Bit Error Rate Testers Jitter Map “Under the Hood”
    Delve into jitter problems in new ways, such as examining Random Jitter on each edge of the data pattern, separating out the jitter caused by transmitter pre-emphasis, and performing jitter decomposition on long patterns such as PRBS-31.  
    애플리케이션 노트
    Stress Calibration for Jitter >1UI
    While measuring the amount of jitter present on a signal is relatively straight forward conceptually; when the levels of jitter are small, amounts above a bit period (1 unit interval or UI) can be more difficult. This has practical consequences for …
    애플리케이션 노트
    Six Sigma’ Mask Testing with a BERTScope® Bit Error Rate Tester
    Six sigma is a form of mask testing that provides for critical insight when mask testing depth specification are important for pass/fail testing or deeper evaluation on high-speed signaling standards to provide a significantly more complete picture …
    애플리케이션 노트
    Bridging the Gap Between BER and Eye Diagrams — A BER Contour Tutorial
    BER Contour Measurement - What it is, how it is constructed, and why it is a valuable way of viewing parametric performance at gigabit speeds.
    애플리케이션 노트
    Clock Recovery’s Impact on Test and Measurement
    As clock recovery becomes increasingly common in more systems and test setups, its effects on measurements must be considered. Many outside influences can disturb the relationship between data and how it is clocked. By understanding the relationship …
    애플리케이션 노트
    Comparing Jitter Using a BERTScope® Bit Error Rate Testing
    Comparison of DCD and F/2 Jitter.
    애플리케이션 노트
    아이다이어 그램기본 기술서
    본 어플리케이션 노트에서는 아이다이어 그램 측정에 대한 노하우 및 전송선, 채널및 리시버 상에서 어떻게 아이다이어 그램을 측정하는지에 대한 기본적인 지식을 습득 하실 수 있습니다.
    애플리케이션 노트
    BERTScope Content Archive
    To request copies of historical content from SyntheSys Research (now Tektronix Inc.) related to BERTScope and the following applications, please click the link below.Request Now
    기술 요약
    Stressed Eye Primer
    In addition to an introduction to stressed eye testing, this primer discusses some of the high-speed standards that use it, and how a receiver test using stressed eye is constructed.
    입문서
    BERTScope™ CR125A, 175A 및 286A 클록 복구 요약서(english)
    Key Specs and Ordering Information for BERTScope CR125A, 175A, & 286A Clock Recovery.
    팩트 시트
    Evaluating Stress Components using BER-Based Jitter Measurements
    This primers describes how jitter measurements can be self-verified using a BER-based Jitter Peak measurement and how to simplify the jitter measurement challenge by using a pattern that does not contribute pattern-dependent effects, and finally …
    입문서
    PCI Express® Transmitter PLL Testing — A Comparison of Methods
    There are several methods of measuring PLL loop response, based on the type of test instrumentation used. As expected, the various methods trade off test accuracy, test speed (throughput), ease of use, ease of setup, and initial cost. In addition …
    입문서
    Clock Recovery Primer, Part 1
    Part 1 of looking at clock recovery from a practical point of view with emphasis on how it affects measurements.
    입문서
    Clock Recovery Primer, Part 2
    Part 2 of looking at clock recovery from a practical point of view with emphasis on how it affects measurements.
    입문서
    Stressed Eye: “Know What You’re Really Testing With”
    BER-based measurements can provide a better view of the stress eye opening down at the deep BER levels that the receiver will be expected to operate at when it is tested.
    입문서
    Characterizing an SFP+ Transceiver at the 16G Fibre Channel Rate
    Study the measurements needed to test an SFP+ transceiver to the 16G Fibre Channel standard, covering both Multi- Mode 850 nm and Single Mode 1310 nm interfaces. Included is a test and characterization example using a Single Mode 1310 nm laser SFP+ …
    입문서
    Dual-Dirac+ Scope Histograms and BERTScan Measurements
    This primer discusses how the dual-Dirac relates to practical measurements that can be made with sampling scopes and BER-based instruments.
    입문서
  • 소프트웨어 문서 유형 부품 번호: 릴리즈 날짜
    BERTSCOPE PC APPLICATION SOFTWARE - V12.04.5608
    The BERTScope PC software provides for PC control of BERTScope Clock Recovery (CR125A, CR175A, CR286A) and Digital Pre-Emphasis Processor (DPP125B) instruments that are being operated as stand-alone instruments, i.e. not connected directly to a …
    애플리케이션 063430807
    BERTSCOPE PC APPLICATION SOFTWARE - V12.04.5522
    The BERTScope PC software provides for PC control of BERTScope Clock Recovery (CR125A, CR175A, CR286A) and Digital Pre-Emphasis Processor (DPP125B) instruments that are being operated as stand-alone instruments, i.e. not connected directly to a …
    애플리케이션 063430806
    BERTScopePC Software, V 10.15.1284
    The BERTScope PC software provides for PC control of BERTScope Clock Recovery (CR125A, CR175A, CR286A) and Digital Pre-Emphasis Processor (DPP125, DPP125B, DPP125C)and BSAITS instruments that are being operated as stand-alone instruments, i.e. not …
    애플리케이션 063430803
    BERTScopeCR Help File V1.0
    BERTScope Clock Recovery Instrument Help File for offline use.
    애플리케이션 066130900
    BERTScopePC Software V 10.9.1024
    The BERTScope PC software provides for PC control of BERTScope Clock Recovery (CR125A, CR175A, CR286A) and Digital Pre-Emphasis Processor (DPP125, DPP125B) instruments that are being operated as stand-alone instruments, i.e. not connected directly to …
    애플리케이션 1000000482
  • This video focuses on the Link Training Status State Machine UI feature of the USB 3.1 Gen2 Receiver test application and shows the path that is taken by a device being trained into loopback mode …
    기간: 4m 35s
    The physical setup for USB 3.1 receiver calibration and testing is shown in this video.
    기간: 4m 33s
    Get an overview of the optical solutions available from Tektronix. Learn about what we showcased at our OFC 2016 exhibit, then learn more about these solutions online.
    기간: 1m 16s
    The USB 3.1 Receiver application's Margin Test feature gives engineers quantitative answers on a design's performance and as a debug tool, a better understanding of where devices fail. This video …
    기간: 3m 34s