DCSIMG

Recommended Equipment

  PHY/TSG/OOB Transmitter Testing RSG/RMT Receiver Testing Rx/Tx Channel Testing SI Cable Testing
Compliance Automation Software
TekExpress (with opt. as mentioned or with opt. SATA-DHB Device or Host SW Bundle) 1 (Opt. SATA-TSG) 1 (Opt. SATA-RSG) 1 (Opt. SATA-RxTx) 1 (Opt. SATA-SI)3
Real-time Oscilloscope1, 4
DSA72004B or DSA71604B or DSA7124 1 1    
Software: DPOJET* (std on DSA) 1 1    
Signal Generator
AWG7122B 1 (Opt. 1, 6, and 8) 1 (Opt. 1 and 6) 1 (Opt. 1 and 6)  
Sampling Oscilloscope
DSA8200     1 1
Modules: 80E04, 80E08, 80E10 TDR Sampling Module     2 4
Software: 80SICON (S-Parameter analysis)4     1 1
RF Switch
Model #: S46-6666A 1 (Optional) 1 (Optional) 1 (Optional)  
SATA Test Fixture
TF-SATA-SET-IV-ZP (Gen1 - Gen2) or TF-1P21 (Plug) and TF-1R21 (Receptacle) fixtures (Gen1 - Gen3) 1 each 1 each 1 each 1 each
SATA-II Frame Error Analyzer
  1    
Cables
Phase Matched SMA Cables (PN 174-4944-01) 5 pair 6 pair 5 pair 4 pair
Attenuator
(PN 015-1001-01) 2 2 2  
LAN Cables
(sharing folders and controlling the instruments over LAN) 2 2    
Connectors
GPIB 488.2 Connections (USB-GPIB) or GPIB cable from controller PC to RF Switch) 1 1    
  1. DPOJET analysis software is required and is included standard on DSA models.
  2. Opt SATA-SI is NOT part of the Device or Host SW Bundle (opt. SATA-DHB).
  3. For Rx/Tx channel testing 80SSPAR can also be used instead.
  4. For compliance testing the Serial ATA specification requires min. 10 GHz BW for Gen 1,2 and 13 GHz BW for Rev 3.0. For Gen1 analysis and debug an 8 GHz bandwidth scope is adequate.
Talk to Us
  • .Tektronix Customer Support Center USA
    • (800) 833-9200 Option 1
  • Change Country

沪ICP备05012376号